ts9011 series 1-1 2003/12 rev. b ts9011 250ma cmos low dropout voltage regulator low power consumption 2ua low drop out voltage 0.4v general description the ts9011 series is a positive volt age regulator developed utilizing cmos te chnology featured very low power consumption, low dropout volt age and high output voltage accuracy. built in lo w on-resistor provides low dropout voltage and large output current. a 1uf or great er can be used as an output capacitor. the ts9011 series are prevented device failure under the worst operation condi tion with both thermal shutdown and current fold-back. these series are recommended for conf iguring portable devices and large current application, respectively. this series are offered in 3- pin to-92, sot-89 and sot-23 package. features dropout voltage typically 0.38v @io=200ma (vo=5v) output current up to 250ma low power consumption, 2ua(typ) @vo=5v output voltage +/-2% internal current limit thermal shutdown protection applications palmtops video recorders battery powered equipment pc peripherals cd-rom digital signal camera ordering information note: where x denotes voltage option, available are d=1.8v, k=2.5v, s=3.3v, 5=5.0v. contact factory for additional voltage options. part no. operating temp. (ambient) package ts9011 x ct to-92 ts9011 x cx sot-23 ts9011 x cy -40 ~ +85 o c sot-89 block diagram typical application circuit pin assignment to-92 & sot-89 1. gnd 2. input 3. output sot-23 1. gnd 2. out 3. input
ts9011 series 2-2 2003/12 rev. b absolute maximum rating input supply voltage vin(max.) +12 v input operating volt age vin(opr.) +10 output current io p d / (vin ? vo) v power dissipation sot-23 sot-89 to-92 p d 0.15 0.50 0.65 w operating junction temper ature range tj -40 ~ +125 o c storage temperature range t stg -65 ~ +150 o c lead soldering temperature (260 o c) 10 s caution: stress above the list ed absolute rating may cause pe rmanent damage to the device. electrical characteristics ta = 25 o c unless otherwise specified. parameter conditions min typ max unit ts90115 4.900 5.0 5.100 ts9011s 3.234 3.3 3.366 ts9011k 2.450 2.5 2.550 output voltage vin=vo + 1v, io =40ma, ts9011d 1.764 1.8 1.836 v maximum output current vin=vo+1v, 250 -- -- ma input stability vo+1v vin 10v, io=5ma -- 0.2 0.3 % ts90115 vin=vo+1v, 1ma i l 100ma ts9011s -- 40 80 ts9011k load regulation (note1) vin=vo+1v, 1ma i l 80ma ts9011d -- 40 90 mv io=250ma ts90115 -- 400 600 io=200ma ts9011s -- 400 650 io=160ma ts9011k -- 400 700 dropout voltage (note 2) io=120ma ts9011d -- 400 750 mv quiescent current vin=vo+1v, io=0a -- 2 5 ua output current limit vout < 0.4v -- 400 -- ma power supply rejection ratio at f=100khz, io=10ma, -- 30 -- db output voltage temperature coefficient (note 3) -- 100 -- ppm/ o c note: 1. regulation is measur ed at constant junction temper ature, using pulsed on time. 2. dropout is measured at c onstant junction temperature, using pulsed on time, and the criterion is vout inside target value +/-2%. 3. guaranteed by design.
ts9011 series 3-3 2003/12 rev. b sot-89 mechanical drawing sot-89 dimension millimeters inches dim min max min max a 4.40 4.60 0.173 0.181 b 1.50 1.7 0.059 0.070 c 2.30 2.60 0.090 0.102 d 0.40 0.52 0.016 0.020 e 1.50 1.50 0.059 0.059 f 3.00 3.00 0.118 0.118 g 0.89 1.20 0.035 0.047 h 4.05 4.25 0.159 0.167 i 1.4 1.6 0.055 0.068 j 0.35 0.44 0.014 0.017 sot-23 mechanical drawing d c a e b g f sot-23 dimension millimeters inches dim min max min max a 2.88 2.91 0.113 0.115 b 0.39 0.42 0.015 0.017 c 1.78 2.03 0.070 0.080 d 0.51 0.61 0.020 0.024 e 1.59 1.66 0.063 0.065 f 1.04 1.08 0.041 0.043 g 0.07 0.09 0.003 0.004 h f e b a g c d j i
ts9011 series 4-4 2003/12 rev. b to-92 mechanical drawing c d a b h e f g to-92 dimension millimeters inches dim min max min max a 4.30 4.70 0.169 0.185 b 4.30 4.70 0.169 0.185 c 14.30(typ) 0.563(typ) d 0.43 0.49 0.017 0.019 e 2.19 2.81 0.086 0.111 f 3.30 3.70 0.130 0.146 g 2.42 2.66 0.095 0.105 h 0.37 0.43 0.015 0.017
|
